This is the body part that I printed for the first time. It looks good in detail. I‘m quite satisfied, but one problem is that his shape is a little too stiff, so I began to try to divide it into three parts of the body period with higher flexibility and higher desire value. In terms of styling, I still want to There are a lot of female characteristics. I just want to show the beauty of women, so I deliberately emphasize her feminine curves. Here is a solution I have researched, that is, how to rationally close the surface of the disordered line, and regroup the re-cable with zmodle first, then delete the side of the line, and then connect several guide lines by edge bridging to close those places with closed holes. In this way, you can get a model with good wiring.
In fact, I have encountered a lot of problems about the splitting of the body, because there are too many details on his body, which will lead to the loss of many details after increasing the joints. I want to make the joints move flexibly and bend the waist reasonably without overmodifying the shape of its body without losing its details as much as much as possible, so that the two-section body is not enough, so I divided it into three sections and added a sphere under the chest cavity and a sphere on the abdominal cavity.
chuyun lu‘s 